Spice Modeling of LED Filament and its Simulation in Switch Drive Circuit

Main Article Content

Qingmei LV

Abstract

When designing the LED filament lamp device and driving circuit at the beginning, software simulation is an indispensable step. It is necessary to verify whether the circuit output results are consistent with the requirements through simulation. In this paper, first measure the volt-ampere characteristics of the actual 1W LED filament strip, and applied the six-segment linear approximation model method for Spice modeling. The simulated volt-ampere characteristics of the 1W model were consistent with the measured volt-ampere characteristics of the 1W LED filament strip. Then use the driver chip HV9910B to design the LED filament lamp switch constant current drive circuit. Combined with the piecewise linear equivalent method, 3W, 4W, 5W LED filament lamp loads are modeled, the detailed design process of the entire circuit is analyzed, and the output voltage, current, inductance output current, MOS output voltage and other parameters of the whole circuit are simulated and verified. The results show that the output voltages are 71V, 142V, 71V, and the output currents are 30.4mA, 20.7mA, 51.1mA respectively under the circuit topology of 3W, 4W, and 5W LED filament lamp. When the inductor current works in CCM mode, the duty cycle of MOS output voltage meets the requirements, and the circuit output results are consistent with the design requirements.

Article Details

How to Cite
LV, Q. . (2021). Spice Modeling of LED Filament and its Simulation in Switch Drive Circuit. CONVERTER, 356-365. https://doi.org/10.17762/converter.299
Section
Articles